Low Voltage

Lighting

Low Voltage

Moonrays full line of Low Voltage lighting is designed to complement any outdoor setting – from casual gardens to formal landscapes. Select from durable plastic or corrosive-resistant metal. Low voltage accent, deck and path lights are easy-to-install and will provide you with consistent light output in all weather.

LOCATION

Before choosing an outdoor lighting option, you should take into consideration the space you will have available. Often small spaces can be overpowered by lighting, and instead of adding ambience; they can actually take away from the overall event.

ADDING LIGHTS

You may add lights to your system as long as their total wattage does not exceed 80% of the total available watts for the transformer. For example, if your transformer is rated at 120 watts, you should not exceed 96 watts in total. If your lights were each 8 watts, you may have 12 lights on the circuit.

Hassle Free

Installation

If you have hesitated adding outdoor lighting to your landscape because you think installation is a hassle, you have not seen the easy installation process of Moonrays Low Voltage Products. Our Low Voltage path lights, deck and patio lights are easy-to-install and easy-to-maintain. If you are ready to take your landscaping to the next level with great Low Voltage outdoor lighting, here are a few installation tips and tricks to get you started.

All of our products feature LED and advanced solar technologies for exceptional illuminatio n.

  • Easy Measurements

    Purchase a low-cost spool of string and lay it out along the path you want your lights to take. Remove and measure the total length and that will be the amount of low-voltage cable you will need. Allow for some extra wire at your fixture placement locations to permit any final adjustments of your light fixtures.

  • Light Fixture Placement

    Using that same string along the designated path, mark the location that you want to place each fixture with a piece of tape. Now you have the perfect map for your project.

  • Installing the Fixture

    Press the stakes securely in the area you wish to light by pressing around the base of the stake. Never press on the top of the fixture. If the ground is too hard, slowly pour hot water on the soil until it softens up.

METAL, GLASS AND
PLASTIC CONSTRUCTION
FLICKERING
FLAME EFFECT
3.3 WATTS
12 volts